Browsing by Subject "ko-amorfia"

The majority of potential new chemical entities reaching drug development phase belong to Class II the Biopharmaceutics Classification System (BCS) which complicates formulation of orally administered drugs. Therefore, there is a need to develop methods to increase the solubility and dissolution rate. Transformation of a crystalline drug into its amorphous form can be used to enhance these properties of poorly water-soluble drugs. However, amorphous drugs are thermodynamically unstable and tend to recrystallize back to the crystalline form. Coamorphous forms are a new and promising method to stabilize amorphous form. A relatively new approach is to combine the active drug compound with an amino acid to form a coamorphous system. In this study, co-amorphous systems were prepared from gamma, alpha or amorphous form of indomethacin (IND) and tryptophan (TRP) by ball milling. The solid-state changes during milling were investigated to obtain information about the co-amorphization process. The main objective was to investigate the effects of initial solid state of indomethacin on the formation pathways. In addition, different analytical methods were compared with respect to observed endpoints of the formation process. Raman spectroscopy has not been used in previous studies regarding solid state changes in co-amorphous forms. The presence of fluorescence in amorphous systems may have limited use of the method. A time-gated Raman setup together with X-ray powder diffraction and differential scanning calorimetry (DSC) was used to investigate this kind of potentially fluorescent system. Principal component analysis of spectral data revealed that the three different binary systems had individual and direct pathways towards the same end points during milling. This indicates that the co-amorphous form formed after 60 minutes of ball milling is not dependent on the initial solid-state form of IND. Straight pathways also indicated direct transformation to the coamorphous form. DSC was found to be the most sensitive method to detect changes for the longest period during co-amorphization. Conventional Raman spectroscopy was found to be suitable for investigation of the co-amorphization process. However, time-gated Raman spectroscopy did not show significant advantages compared to conventional Raman data. This study revealed that the most stable form of IND could be used for production of co-amorphous form together with TRP. Raman spectroscopy could potentially be used for investigating coamorphization also as an in-process analytical method.