Browsing by Subject "3D layer model"

Tiivistelmä/Referat – Abstract This study investigates temperature data that Posiva Oy has from the Olkiluoto and ONKALO® sites. The aim of the study was to create a unifying data classification for the existing temperature measurements, give an estimate of the initial undisturbed bedrock temperature and temperature gradient and model the temperature profiles in 3D. The thermal related issues, which the repository will undergo once in operating are significant and have fundamental contribution to the evolution of the repository, creating a need in such a study. Posiva Oy has temperature data obtained with four main methods; Geophysical drillhole loggings, Posiva flow log (PFL) measurements, thermal properties (TERO) measurements and Antares measurements. The data classification was carried out by creating a platform of quality aspects affecting the measurements. The classification was then applied for all the available data by inspecting the measurement specifics of each configuration and by observing the temperature/depth profiles with WellCad software. According to the specifics of each individual measurement the data was classified into three groups: A= the best data, recommended for further use, and which fulfils all quality criteria, B= data that should be used with reservation and which only partly fulfils quality criteria, and C= unusable data. Only data that showed no major disturbance within the temperature/depth profile (class A or B) were used in this study. All the temperature/depth data was corrected to the true vertical depth. The initial undisturbed average temperature of Olkiluoto bedrock at the deposition depth of 412 m and the temperature gradient, according to the geophysical measurements, PFL measurements (without pumping), TERO measurements and Antares measurements were found to be 10.93 ± 0.09°C and 1.47°C/100m, 10.85 ± 0.02°C and 1.43°C/100m, 10.60 ± 0.08°C and 1.65°C/100m, and 10.75°C and 1.39°C/100m, respectively. The 3D layer models presented in this study were generated by using Leapfrog Geo software. From the model a 10.5 – 12°C temperature range was obtained for the deposition depth of 412 – 432 m. The models indicated clear temperature anomalies in the volume of the repository. These anomalies showed relationship between the location of the major brittle fault zones (BFZ) of Olkiluoto island. Not all observed anomalies could be explained by a possible cause. Uncertainties within the modelling phase should be taken into consideration in further interpretations. By combining an up-to-date geological model and hydraulic model of the area to the temperature models presented here, a better understanding of the temperature anomalies and a clearer over all understanding of the thermal conditions of the planned disposal location will be achieved. Based on this study a uniform classification improves the usability of data and leads into a better understanding of the possibilities and weaknesses within it. The initial bedrock temperature and the temperature gradient in Olkiluoto present thermally a relatively uniform formation. The estimates of the initial bedrock temperatures and the temperature gradient presented in this study, endorse previous estimates. Presenting the classified temperature data in 3D format generated good results in the light of thermal dimensioning of Olkiluoto by showing distinct relationships between previously created brittle fault zone (fracture zone) models. The views and opinions presented here are those of the author, and do not necessarily reflect the views of Posiva.